Set your zones
Until you have a threshold, every intensity target is a guess. Pick one of three ways:
1. Field test (today, free)
In the Baseline check card, choose the test for your sport, press How to do it, do the test, then enter the result.
| Sport | Test |
|---|---|
| Run | 30 minutes as hard as you can hold. Enter the average heart rate for the last 20 minutes, plus distance if you have it. |
| Run: 6 minute all-out | As far as you can in 6 minutes. Gives your speed at VO₂ max (vVO₂max) and a VO₂ max estimate. |
| Run: critical speed | As far as you can in 3 minutes, then (after 30 minutes' recovery) in 12 minutes. Gives critical speed (close to threshold) and D′, your reserve above it. |
| Bike | 20 minute FTP test |
| Swim (triathletes) | CSS test |
| Hyrox | 1000 m ski and row, a compromised run, the station trade-off test, and station benchmarks |
Your zones are set the same day, labelled Field tested.
The two thresholds, and which test finds which
Your five zones hang off two lines. The 30-minute test finds the upper one (your threshold, LT2). It doesn't find the lower one, your aerobic threshold (LT1, the top of Zone 2). Until you check that, the dashboard estimates it from the upper one.
The drift test finds your aerobic threshold:
- Warm up 15 minutes. Use a flat route or a treadmill.
- Run 60 minutes holding one steady heart rate, your best guess at the top of Zone 2.
- Look at the heart-rate drift: pace against heart rate, first half versus second half. intervals.icu shows it as Pa:Hr on the activity, and your dashboard shows it in the session detail and the Durability chart.
- Under 5%: that heart rate is at or below your aerobic threshold. Over 5%: it's above. Drop 5 bpm and repeat on another day.
- Once you've found it, enter it as your aerobic threshold in My numbers (labelled Entered by you).
Drift in a single steady hour tells you where your aerobic threshold is. Drift across months of long runs tells you about your durability: a different question, answered by the Durability chart.
The drift test: your aerobic threshold, the top of Zone 2
The one test that sets Zone 2 directly. Under Run a field test, pick Drift test. Warm up, then run 20 minutes at an easy pace held exactly even, lap at 10 minutes, then 20 minutes about 15 to 20 seconds per km faster, lap at 10. Enter each stage's average heart rate for the first and last 10 minutes. If heart rate climbed more than about 5% in a stage, that pace was above your aerobic threshold; if it held, you were under it. The fastest steady stage sets your aerobic threshold, labelled Field tested, and that's the ceiling every easy run is then checked against. Do it fresh, on a flat route, in cool conditions: heat, dehydration and caffeine all push heart rate up and make the test under-read. It gives the aerobic threshold only, so pair it with the critical speed or 30 minute test for the full set of zones. The 5% rule is a coaching rule of thumb, not a validated cut-off.
2. Box lab test (measured)
Book a VO₂ max and threshold test, or an RMR and body composition test: https://boxnutrition.co.uk/which-test
Results appear in your dashboard automatically, labelled Lab measured. Anyone tested at Box gets the dashboard free.
3. Tested somewhere else?
Open Tested somewhere else? in the Baseline check card. Enter the lab's name, the date and whatever they gave you: VO₂ max, aerobic threshold, threshold, threshold pace, RMR, body composition. These show as Reported · [lab name].
You should see your thresholds in the Testing panel, and the targets in your week change from "feel" to real numbers.
Formula vs measured
Once you have a threshold, the Testing panel compares it with what a formula would have guessed. For example: "A formula would put your aerobic threshold at 149–161 bpm. Yours was measured at 123 bpm, 26 bpm lower. Easy days set by the formula would have been too hard."
When to retest
Zones go stale as fitness changes. The dashboard flags any test more than 12 weeks old.
Hyrox: the station trade-off test
Going flat out on a station saves time on the station, but it can cost you more on the kilometre after it, because you've dug into the reserve you run on above threshold. This test measures that trade on you, one station at a time.
- Warm up. Run 1 km at race effort, then do the station at a controlled effort (about 7 out of 10), then 1 km at the same effort.
- Rest until fully recovered, 10–15 minutes.
- Repeat it with the station flat out, keeping both kilometres at race effort.
Enter the six times. The Hyrox pacing guide then says, for that station, Hold back or Go hard, with the seconds saved and lost. Untested stations default to about 7 out of 10. Wall balls are always Go: nothing comes after them.
Hyrox: race and simulation analysis
On the Hyrox view, My lab → Race analysis. Paste your splits from the results page (the times are read in race order: run 1, SkiErg, run 2, sled push… then Roxzone and your finish), check them, and save. Simulations work the same way.
You get your finish time, runs, stations and Roxzone as a share of it, where you lost time against your pacing guide, your eight runs side by side with the station before each, and, from your second result on, what's improved.
Share my result and Share what I've improved make an image for a post (4:5) or a story (9:16). Add a photo behind it if you like: it stays on your phone or computer and is never uploaded.
Am I getting fitter?
Above your pace curve in My lab there's a trend line of your predicted race time, one point per six weeks, over the last 13 months. Each point is fitted from your best 1K to 10K efforts in that window, the same way as the pace curve, so it only moves when your running does. It needs intervals.icu connected and a few hard efforts in a window; windows without them are skipped rather than guessed. The headline says whether you're faster, slower or holding steady over the last six months. Changes under about 2% are within the method's noise, so a small wobble isn't a trend. If you have a goal race, the time is shown for that distance.